The effect of konjac gum, sage seed gum, homogenization rate and fat content on pH, texture, and color of low fat stirred yogurt

Document Type : Full Research Paper

Authors

• Masoud Najaf Najafi ¹
• Haminreza Shateri ²
• Morteza Kashaninejad ³

¹ Food Industries Department, Khorasan Razavi Agricultural and Natural Resources Research and Education Center, AREEO, Mashhad, Iran.

² Novel Dairy Products Manufacture, Khorasan Razavi Agricultural and Natural Resources Research and education Center, AREEO, Mashhad, Iran.

³ Department of Food Science and Technology, Ferdowsi University of Mashhad (FUM), Mashhad, Iran.

https://doi.org/10.22067/ifstrj.v17i1.82102

Abstract

Introduction: It can be seen that in most studies published on low fat yogurt, the effects of fat substitutes or process changes, including the homogenization process, have been considered separately. However, process changes, especially changes in homogenization pressure, in addition to the effect on yogurt, has also an effective role on fat substitutes such as hydrocolloids and can affect their functional characteristics. Therefore, in order to understand the proper conditions of industrial production, it is necessary to study these changes simultaneously. Due to the importance of low fat yogurt production, the effect of konjac gum, sage seed gum, homogenization rate and fat content on pH, texture, and color of low-fat yogurt was investigated using mixture-process variable experiments and modeling the properties obtained from this experimental method.
 
Materials and methods: To prepare low-fat yogurt, firstly, the cream of 40% fat was added to the milk with 0.05% fat, sage seed gum, and konjac gum were added according to the design treatments and calculated by Pearson square method. The preparation was then heated to 90 °C and cooled down to 45 °C. The starter was then added and incubated in oven until reaching pH = 4.6. The yogurt was cooled down and dispersed in a 100 g cups of polyethylene. Texture analyzer was used for combination of back extrusion and texture profile analysis (TPA) test. The evaluated parameters were: hardness (N), cohesiveness, springiness, gumminess (N), chewiness (N), adhesiveness and adhesiveness force. pH was measured according to AOAC official method NO. 981.12.
 
Results and discussions: The results showed that only the effect of fat content on the 99% level was significant on the pH of the samples, while konjac, sage seed gum, and homogenization rate had no significant effect. By increasing the fat content, the pH of the samples also significantly increased. It is likely that the increase in fat content will reduce the metabolic activity of the starter bacteria and thus increase the pH of the samples. Also, when the fat content of the samples was kept constant (1.75%), increasing the konjac gum and reducing the sage seed gum when the homogeneity of the samples was between 0 and 1200 rpm, the hardness of the samples initially increased and then decreased. When both gums were added at the same level, the hardness decreased indicating the high synergistic effect of these gums at low homogeneity rates. The results of this study showed that only linear effect of fat in 99% level on the adhesiveness force of samples was significant so that by increasing the fat content, the adhesiveness force of the samples increased. Also, the results showed that with increasing the konjac gum and reducing the sage seed gum, the gumminess of the samples first increased and then decreased. The most gumminess sample was in the conditions that both gums were used at the same level, indicating the high synergistic effect of these gums on the gumminess of the samples. The results of color measurement showed that only the linear effect of sage seed gum and the interaction effects of konjac gum-sage seed gum, konjac-gum on homogenization rates of L* samples were significant, and with increasing the level of konjac gum and reducing sage seed gum, L* samples decreased, but with increasing homogenization rates, L* samples increased. In this research, minimization of the fat content and adhesiveness force and maximization of the hardness and cohesiveness was considered as optimization aims. The optimum point calculated as 0.146% konjac gum, 0.053% sage seed gum, 2.42% fat content and 12300 rpm homogenization rate. In this conditio, the responses were: pH=4.5, hardness=3.25 N, adhesiveness force=0.815 N, cohesiveness 0.258 mm and L* 85/18. As a conclusion of this investigation, it could be said that these types of models could be utilized in industries to optimizing the formulation of such product, reducing the cost and increasing the acceptance.

Keywords

• Konjac gum
• Sage seed gum
• Homogenization rate
• Back extrusion test
• Texture Profile Analysis
• Low fat stirred yogurt

References

Aguirre-Mandujano, E., Lobato-Calleros, C., Beristain, C. I., Garcia, H.S., & VernonCarter, E.J. 2009. Microstructure and viscoelastic properties of low-fat yoghurt structured by monoglyceride gels. Food Science and Technology, 42, 938-944.

Aziznia, S., Khosrowshahi A., Madadlou A., & Rahimi J. 2008. Whey Protein Concentrate and Gum Tragacanth as Fat Replacers in Nonfat Yogurt: Chemical, Physical, and Microstructural Properties. Journal of Dairy Science, 91:2545-2552.

Behnia, A, Karaghian,H , Niazmand,R., & Mohammadi Nafchi, A.R. 2013. The effect of using sunflower gum on the physicochemical properties of low-fat yogurt. The 21st National Congress of Food Science and Technology.

Bourne, M. C. 1978. Texture profile analysis. Food Technology, 32, 62–66, 72.

Chua, M., Chan, K., Hocking, T.J., Williams, P. A., Perry, C. J., & Baldwin, T.C . 2012. Methodologies for the extraction and analysis of konjacglucomannan from corms of Amorphophalluskonjac K. Koch. Carbohydrate Polymers 87(3) 2202–2210.

Dal Belloa, L.H.A., & Vieirab, A.F.C. 2011. Optimization of a product performance using mixture experiments including process variables, Journal of Applied Statistics, 38(8), 1701–1715.

Demirkesen, I., Mert, B., Sumnu, G., & Sahin, S. 2010. Rheological properties of gluten-free bread formulations. Journal of Food Engineering 96: 295–303.

Dolz, M., Hernandez Delegido, J., Alfaro, M.C., & Munoz, J. 2007. Influence of xanthan gum and locust bean gum upon flow and thixotropic behavior of food emulsions containing modified starch. Journal of Food Engineering 81: 179–186.

Fiszman, S. M., Lluch, M. A., & Salvador, A. 1999. Effect of addition of gelatin on microstructure of acidic milk gels and yoghurt and on their rheological properties of yoghurt. 21st National Congress of Food Science and Technology

Guggisberg, D., Cuthbert-steven, J., Piccinali, P., Butikofor, U., & Eeberhand, P. 2009. Rheological, microstructural and sensory characterization of low-fat and whole milk Set yoghurt as influenced by inulin addition. Internation Dairy Journal .19:107115

Guven, M., Yasar, K., Karaca, O.B., & Hayaloglu, A.A. 2005. The effect of inulin as a fat replacer on the quality of set type low, fat yogurt manufacture. International Journal of Dairy Technology, 58 (3): 180- 184.

Isleten, M., & Karagul-Yuceer, Y. 2006. Effects of dried dairy ingredients on physical and sensory properties of nonfat yogurt. Journal of Dairy Science., 89,2865-2872.

Kayacier, A., & Dogan, M. 2006. Rheological properties of some gums-salep mixed solutions. Journal of Food Engineering 72: 261–265

Mahdian, E., Mazaheri, M., & Karazhyan, R. 1391. Effect of fat content of milk on the growth and metabolic activity of starter cultures and quality of concentrated yoghurt, IJFST 3,1.

Mandala, I., Kapetanakou, A., & Kostaropoulos, A. 2008. Physical properties of breads containing hydrocolloids stored at low temperature. II. Effect of freezing. Food Hydrocolloids 22: 1443– 1451.

Merrill, R.K., Oberg, C., & McMahon, D. 1994. A method for manufacturing reduced fat Mozzarella cheese. J. Dairy Sci. 77: 1783–1789.

Mortazavian, A.M., Ehrani, M.R., Mousavi, S.M., Reinheimer, J.A., Emamjomeh, Z., Sohrabvandi, S., & Rezaei, K. 2006. Preliminary investigation of the combined effect of heat treatment and incubation temperature on the viability of the probiotic microorganisms in freshly made yogurt. International Journal of Dairy Technology, 59:8-11.

Motamedzadegan, A., Shahidi, A., Hosseini Parvar, H., & Abdali, S. 1392. Investigating the Effect of Gelatin Type on Functional Properties of Non-Fatty Shaped Yogurt. Journal of Food Science and Technology, 47, 221-230

Nouri, M., Ezzatpanah, H., & Abbasi, S. 2011. Application of renneted skim milk as a fat mimetics in nonfat yoghurt. Food and Nutrition Sciences, 2, 541-548.

Park, Y. W. 2007. Rheological characteristics of goat and sheep milk. Small Ruminant Research, 68(8), 73–78.

Perry, D.M., McMahon, D., & Oberg, C. 1997. Effect of exopolysaccharideproducing cultures on moisture retention in low fat Mozzarella cheese. Journal of Dairy Science. 80: 799–805.

Prentice, J.H. 1992. Dairy Rheology, VCH Publishers, Inc.cambridge, England.

Purwandari, U., Shah, N.P., & Vasiljevic, T. 2007. Effects of exopolysaccharide producing strains of Streptococcus thermophilus on technological and rheological properties of set-type yoghurt. International Dairy Journal 17: 1344-1352.

Razavi, S.M.A., HasanAbadi, M., Ghadiri, G.R., & Salehi, E. A. 2013. Rheological interaction of sage seed gum with xanthan in dilute solution. International Food Research Journal 20(6): 3111–3116.

Rudan, M.A., Barbano, D.M., Yun, J.J., & Kindstedt, P.S. 1998. Effect the modification of fat Particle size by homogenization on composition, proteolysis, functionality and appearance of reduced fat Mozzarella cheese. Journal of Dairy Science, 81: 2065-2076.

Sandoval-Castilla, O., Lobato-Calleros, C., Aguirre-Mandujano, E., & Vernon-Carter, E.J. 2003. Microstructure and texture of yogurt as influenced by fat replacers. International Dairy Journal, 14, 151–159.

Tamime, A.Y., & Robinson, R.K. 1999. Yogurt science and Technology Woodhead Publishing Ltd and CRC Press Uc.

Walkenström, P., Kidman, S., Hermansson, A., Rasmussen, P.B., & Hoegh, L. 2003. Microstructure and rheological behaviour of xanthan/pectin mixed gels. Food Hydrocolloids, 17, 593–603.

Walstra, P., Geurts, T. J., Noomen, A., Jellema, A., & van Boekel, M. A. J. S. 1999. Dairy Technology—Principles of Milk Properties and Processes, Marcel Dekker, New York

YadeMellat, M. 1396. Effects of application of some local gums on physicochemical, textural and sensory properties of stirred yogurt. Master's thesis, Ramin Agriculture and Natural Resources University of Khuzestan College of Agriculture Department of Food Science and Technology.

Zhang, L., Xue, Y., Xu, J., Li, Z., & Xue, C. 2015. Effects of deacetylation of konjac glucomannan on Alaska Pollock surimi gels subjected to high-temperature (120 ̊C) treatment, Food Hydrocolloids, 43, 125-131.