Food Chemistry
Mozhgan Akbari; Reza Farhoosh; M. Moinfard
Abstract
IntroductionToday, many edible oils such as palms, corn, soybeans and sunflowers are used in food preparation. Essential oleic, linoleic and linolenic fatty acids, found abundantly in olive, sunflower and soybean oils, respectively, play an important role in maintaining health. Antioxidant compounds ...
Read More
IntroductionToday, many edible oils such as palms, corn, soybeans and sunflowers are used in food preparation. Essential oleic, linoleic and linolenic fatty acids, found abundantly in olive, sunflower and soybean oils, respectively, play an important role in maintaining health. Antioxidant compounds are used to increase the shelf life of oils, which are classified into two groups of natural and synthetic antioxidants based on the source of production. Phenolic acids are a subset of a large group of phenolic compounds that are used as natural antioxidants in industry. Gallic acid is much stronger than protocatchuic acid due to its three hydroxyl groups. However, the presence of more than three hydroxyl groups does not seem to increase the antioxidant effect in oily systems. The position of the hydroxyl group on the aromatic ring also affects the antioxidant activity, so that the replacement of the hydroxyl group in the ortho and para position increases the antioxidant activity of phenolic acids. Methyl gallate, which is widely found in plants and polyphenolic secondary metabolites, is a natural antioxidant. Despite efforts to date, no suitable natural antioxidant has been proposed to control the thermal oxidation of oils at high temperatures. Therefore, due to the widespread use of oils in food, the thermal stability of natural antioxidants gallic acid and methyl-gallate compared to the powerful but synthetic antioxidant TBHQ, depending on the degree of satiety of the lipid system (sunflower oil and olive oil) and 80 degrees Celsius will be evaluated in this study.Material and MethodsSamples of sunflower and olive oil were purchased from local stores. All chemicals and solvents were provided by Merck and Charlot. Sunflower and olive oil were purified by column chromatography to remove natural antioxidants. Oxidation of purified sunflower oil (1 g per oil) in the presence of a concentration level of gallic acid, methyl gallate and TBHQ (1.2 μmol / g) in glass bottles. The rate of progression of oxidative reactions and the evaluation of oil quality during temperature application is possible by measuring the peroxide number. The carbonyl number is determined using 2-propanol as solvent and 2,4 decodenal as standard and absorbance at 420 nm. The effect of antioxidants (InH) on the oxidation of the test samples can be measured based on the kinetic parameters. These parameters are stability factor F, ORR oxidation rate ratio, activity A and average consumption of WInH antioxidants.Results and DiscussionThe minimum and maximum induction times are related to the control sample and the sample containing the synthetic antioxidant TBHQ, respectively, which, considering the position of the two hydroxyl groups in the para position relative to each other in the TBHQ molecule, make this antioxidant stronger. Justifies. At 80 ° C and in sunflower oil, the antioxidant methyl gallate shows a more effective stability factor (F) and antioxidant activity (A), indicating greater antioxidant power than gallic acid. Similarly, F-ORR-A values in methylgalate treatment have a significant effectiveness compared to other treatments. The higher oxidative stability of olive oil against sunflower oils can be attributed to the small amounts of oleic acid and especially the small amounts of linolenic acid in olives. Stability factor (F), is significantly higher for the TBHQ antioxidant than the values obtained for the other two. This factor is affected by the induction period of antioxidants and can be expected due to the effectiveness of antioxidants in increasing the duration of the induction period. The highest value obtained for the ORR oxidation rate parameter, is related to the antioxidant gallic acid. The parameter of antioxidant activity A, in TBHQ is higher than the other two antioxidants. Measurement of carbonyl compounds resulting from the decomposition of hydroperoxides is a good measure of the rate of development of oxidative reactions. In the treatment of gallic acid and TBHQ, the changes in the carbonyl number decrease at the end of the annealing, which is probably due to the decomposition of carbonyl compounds and the production of polymer compounds. Which cannot be measured by carbonyl number test.ConclusionBetter efficacy of gallic acid compared to methyl gallate in olive oil and better efficacy of methyl gallate compared to gallic acid in sunflower oil at 80 ° C show the composition of fatty acids, the nature of lipid systems and the position of antioxidants in the reaction medium. , Have a great effect on improving the performance of antioxidants. Determination of oxidative stability based on carbonyl number shows similar results to peroxide number .
Food Engineering
Morteza Kashaninejad; Seyed Mohammad Ali Razavi; Mohammad Reza Salahi
Abstract
Introduction: One of the products that its production has not been investigated well and is an imported product is cream powder. Foam mat drying is a widespread technique to dehydrate liquid or semi-liquid foods with high viscosity, adhesion and high sugar content, which are usually difficult to dry. ...
Read More
Introduction: One of the products that its production has not been investigated well and is an imported product is cream powder. Foam mat drying is a widespread technique to dehydrate liquid or semi-liquid foods with high viscosity, adhesion and high sugar content, which are usually difficult to dry. Evaluating moisture content over time is the first indication of how the drying process is performed and can be used as a tool to compare the drying behavior of food. The rate of drying, which is expressed as a function of time or moisture content, is also a very important parameter that helps to understand drying properties of a material. Color can also indicate chemical changes in food during the thermal process such as browning and caramelization. Therefore, since in the drying industry, process time, product quality, optimization and equipment design are directly affected by the rate of drying of food, hence, in this study, in the process of drying the camel milk cream by the foam mat drying method, drying operation at temperatures of 45, 60 ,and 75 °C and thicknesses of 1, 3 and 5 mm was performed in a non-continuous cabinet dryer to evaluate the kinetics of drying , structure and color of the dried foam. Materials and Methods: Camel milk cream was mixed with carboxymethyl cellulose (0.1%), cress seed gum (0.1%) and 80% whey protein concentrate (5%) at 25 ° C. After pasteurization, the samples were stirred with a mixer at a maximum speed of 1500 rpm (5 minutes) for proper aeration. The foam samples were poured into a plate in a thin layer with thicknesses of 1, 3 and 5 mm and then dried in a dryer at temperatures of 45, 60 and 75 ° C until a constant moisture was reached. The process treatments were performed in a completely randomized central composite design (CCD) (5 replications at the center point) for 2 variables at three levels. The effective diffusion coefficient was calculated based on the second Fick's law of diffusion. Then, using Arrhenius equation, which shows the relationship between temperature and effective diffusion coefficient, activation energy was also calculated. After the drying stage, in order to investigate the changes in moisture during the drying, by determining MR, we have used some experimental models that were previously used for drying agricultural products, to fit the experimental data using the statistical software MATLAB 2016. Results and Discussion: The results showed that increasing the temperature from 45 to 75° C reduced the drying time of the samples by almost 50%. Reducing the thickness from 3 to 1 mm led to an 80% reduction in drying time of the samples. The overall effective diffusion coefficient of the tested samples varied between 7.09×10-10 and 8.11× 10-9 m2/s. The increase in the temperature led to an increase in the effective diffusion coefficient of the samples. The activation energy of the samples varied between 25.59 and 38.22 kJ /mol, and comparison of the means showed that the activation energy of the samples was also increased by increasing the foam thickness. Totally, 17 models were evaluated to investigate the drying kinetics of the samlses and in all cases of foam drying , page and Midilli models with R2 values above than 0.99 and the lowest values of RMSE indicate the best fit with the experimental data among the 17 fitted model. Examining the digital images of the samples also showed that at low temperatures, the structure of the dried foams was smooth and it became more uneven and porous as a result of increasing the temperature. Also, the trend of changes in the parameters of the gray level co-occurrence matrix (GLCM) (energy, correlation, and homogeneity) of the samples was almost the same with the changes in temperature and thickness so that, the increase in the drying temperature and a decrease in the thickness of the samples led to a decrease in these parameters. Increasing the foam thickness at high temperatures led to a decrease in the browning index and at low temperatures, led to an increase in the browning index of the samples.
Mohammad Reza Toorani; Reza Farhoosh; Mohammad Taghi Golmakani; Ali Sharif
Abstract
Introduction: Lipid oxidation is one of the most important factors affecting the loss of quality or the deterioration of edible oils. This reaction is accompanied by the production of harmful compounds that may threaten consumer’s health. Several parameters affect the severity of the oxidation ...
Read More
Introduction: Lipid oxidation is one of the most important factors affecting the loss of quality or the deterioration of edible oils. This reaction is accompanied by the production of harmful compounds that may threaten consumer’s health. Several parameters affect the severity of the oxidation reaction, among them temperature is one of the most important parameter to consider. Lipid oxidation increase significantly with the increase of temperature, which drastically reduces the length of the shelf life of the oils. Numerous methods have been used to postpone the oxidation of oils that one of the most useful methods is the addition of antioxidants. Nowadays, natural antioxidants have been located in the hotspot of attention from safety and sensory characteristics point of view. Sesamol as a valuable natural antioxidant may help to provide healthy edible oils. The determination of thermal kinetic data and the evaluation of thermodynamic indices have long been used to the better identify the mechanisms and the events caused by temperature elevation. Examining the temperature and time variables together and merging these components could provide valuable information about the environmental effects of foodstuffs. These parameters are particularly important for edible oils. Hence, the kinetic-thermal information of the oils oxidation in the presence of sesamol may provide the valuable assistance in explaining the storage conditions of various edible oils in the presence of this antioxidant. Materials and methods: The sesamol's ability to quench free radicals was determined by DPPH test and at 517 nm. The oil purification process was performed by adsorption column chromatography in order to eliminate minor components that may be interfere with the oxidation reaction. The evaluation of the accelerated oxidation process in presence of sesamol was carried out in a dry oven and through monitoring the accumulation of hydroperoxides (peroxide value) over time at 60, 80 and 100 °C. The peroxide value was measured spectrophotometrically at 500 nm. The induction period of oils oxidation was determined through two lines fitted on initiation and propagation steps of the oxidation curve. The rate constants of the oils oxidation and sesamol consumption, the peroxide value corresponding to the length of induction period (PVIP), the minimum sesamol concentration to demonstrate the antioxidant activity and the oxidative stability time of lipid systems at ambient temperature were also determined by oxidation kinetic data. Results and discussions: The results of inhibitory test showed that the amount of sesamol required to inhibit 50 percent of the DPPH radicals is equal to 1 mM. The induction period of olive oil has reached to over 520 h in presence of 0.01% sesamol at 60 °C, whereas sesame and canola oils were placed in the subsequent positions with nearly 330 and 325 h, respectively. The average extent of PVIP (all sesamol concentrations) for two lipid systems i.e. sesame and canola oils was close to each other and drastically higher from olive oil. This delocalization of the numbers suggests that the PVIP is independent of the antioxidant concentration available and is affected by the fatty acids structure of oils. The effect of temperature elevation on the rate constant of oxidation for different oils did not follow the same pattern, so that the slope of increase of the rate constant for olive oil was very mild than to the other two oils. The results showed that the increase in temperature has markedly increased the rate of sesamol consumption, so that unsaturated lipid systems have undergone significant changes in this regard. Increasing the temperature increased the minimum concentration required for the antioxidant activity of sesamol. This pattern was linear for olive oil and hyperbolic for sesame and canola oils.