Food Technology
Rahman Yousefi; Mohammadreza Pourghayoumi; Seyyed Samih Marashi; Ali Ghasemi
Abstract
IntroductionDate palm (Phoenix dactylifera) is one of the most important horticultural products in arid and semi-arid regions of Iran. One of the factors affecting the quality and nutritional elements of date fruit- as an important and strategic fruit in the country, with high nutritional and health ...
Read More
IntroductionDate palm (Phoenix dactylifera) is one of the most important horticultural products in arid and semi-arid regions of Iran. One of the factors affecting the quality and nutritional elements of date fruit- as an important and strategic fruit in the country, with high nutritional and health value- is the proper use of different nutritional elements during its growth and fruiting period. There are many reports of the negative effects of salinity on dates, both in the vegetative and reproductive growth stages. The osmotic effects limiting the absorption of water and nutrients, the specific effect of chlorine and sodium ions, nutritional imbalance and preventing the physiological processes and metabolism of nutrients and the use of high energy in osmotic regulation are some of the negative effects of salinity stress. Salinity stress negatively affected date fruit quality. Silicon is one of the essential nutrients that plays an important role in the growth and development of plants. Silicon reduces the adverse effects of abiotic stresses such as drought and salinity by affecting on the leaf and stem growth, and other plant mechanisms. Therefore, the aim of this study was to investigate the effect of foliar application of silicon on some qualitative characteristics and nutrient elements content of date fruit grown under high salinity soil. Materials and Methods This research was conducted in a randomized complete block design with 7 treatments and 3 replicates in two consecutive years. Silicon foliar spray treatments consisted of: control or no application of foliar spraying (T1), foliar spraying with a concentration of 0.1% in two stages (T2), foliar spraying with a concentration of 0.1% in three stages (T3), foliar spraying with a concentration of 0.2% in two stages (T4), foliar spraying with a concentration of 0.2% in three stages (T5), foliar spraying with a concentration of 0.3% in two stages (T6) and foliar spraying with a concentration of 0.3% in three stages (T7). The treatments were repeated in two consecutive years, and in each fruiting season, fruit quality characteristics including total soluble solids (TSS), acidity (TA), pH and total sugar content were measured. Total sugar was measured according to Iran's national standard method No. 2685 (ISIRI, 2007). The concentrations of potassium, calcium, iron and zinc were also measured at the end of the second year of the experiment. Fruit quality characteristics and concentration of fruit nutrients were measured and statistically analyzed. Results and DiscussionFoliar application of silicon fertilizer significantly increased the TSS of ‘Barhee’ date fruits while it decreased the pH of fruit juice. The lowest amount of total soluble solids was observed in T1 treatment at the rate of 63.69% and the highest amounts of fruit soluble solids were recorded in T5 and T6 treatments with values of 70.07% and 68.59% respectively. Fruit acidity and total sugar were not affected significantly by foliar application of silicon. The application of silicon significantly increased the contents of potassium, calcium, iron and zinc in date fruit, but it had no significant effect on the concentration of phosphorus in the fruit. The highest concentration of fruit potassium was observed in the T6 treatment (spraying with 0.3% silicon solution in two stages) at the amount of 1.54%. The lowest values of potassium concentration were observed in T3, T2 and T1 treatments with values of 0.89%, 1.01% and 1.06% respectively. Overall, Foliar application of silicon fertilizer can improve the quality characteristics and nutrient concentration of date fruit under salinity stress conditions. Among all the treatments, foliar application of silicon fertilizer with a concentration of 0.3% in two stages (three weeks before pollination and at the end of the Hababook stage) improved quality characteristics and the nutrient elements of ‘Barhee’ date fruit under high salinity soil.
Food Technology
Somayeh Ghandehari alavijeh; Mehran Alami; Yahya Maghsoudlou; Alireza Sadeghi Mahoonak
Abstract
Introduction: Porous starch granules are becoming of great interest such as non-toxic absorbents, owing to their great absorption capacity derived from the major specific surface area. Pores can protect sensitive elements as oils, minerals, vitamins, bioactive lipids, food pigments such as beta-carotene ...
Read More
Introduction: Porous starch granules are becoming of great interest such as non-toxic absorbents, owing to their great absorption capacity derived from the major specific surface area. Pores can protect sensitive elements as oils, minerals, vitamins, bioactive lipids, food pigments such as beta-carotene and lycopene that are sensitive to light, oxidation or high temperature. Alpha-amylases from Bacillus and glucoamylases from Aspergillus niger have the strongest hydrolytic ability toward starch. Ultrasonic treatments have been reported to produce modified starch. In the last years, the effects of sonication on the starch microstructures and properties have been studied. It was shown that the C–C bonds of starch granules were destroyed, and hollows or pores were formed on the surface and inside the granules. Therefore, the main objective of this study was to identify a suitable starch (corn or wheat) to carry and protect iron ions. The enzyme having a fixed concentration of 0.1% within a fixed period of 36 hour, was added to the starch solutions in three different steps - after, simultaneously and before - the ultrasound processes. The power of the ultrasound was 350 watt for 10 minutes. Iron ions (Iron Ammonium Sulfate (II)) were added to the porous corn and wheat starches in concentrations of 40, 60 and 80 ppm. Materials and methods: The ability of water and oil adsorptions were measured in the produced corn and wheat porous starches. The microstructures of porous starches were revealed by using Scanning Electron microscopy (SEM). After adding iron ammonium sulfate (II) to the porous starches of corn and wheat, the amount of iron ions absorbed and the type of bonds formed between starch and iron ions were determined by inductively coupled plasma (ICP) and infrared spectroscopy (FTIR), respectively. Statistical analysis was performed by using SPSS software and the mean comparison test at 5% probability level and in the form of factorial test. Results & Discussion: The hydration capacity in processed wheat starch was lower than corn starch due to the differences in granular structure of wheat and corn starch. The hydration capacity in native wheat and corn starches was significantly (p < 0.05) lower than the processed forms. No significant difference (P>0.05) was observed between the three steps of adding enzyme (e after, simultaneously and before the ultrasound processes). According to the results, the oil adsorption capacity in the processed starches was more than that of the native forms. Scanning Electron Microscopy (SEM) shows that the native corn and wheat starch granules appeared without any clear of fissures, fractures and pores. The corn and wheat starches which were treated by the enzyme after (step 1), simultaneously (step 2) and before (step 3) the ultrasound change and lose their smooth surfaces and become uneven. The surface of corn granules in group 2 and 3 have less pores and porosities with more laminated. In simultaneously processes (phase 2) the ultrasound causes the enzyme to be inactivated. In phase 1, it can be concluded that the ultrasound helps the enzyme performance in creating the porosities and cavities. The wheat granules in step 1, 2 and 3 have a lot of damage on the surface and it is likely that the surface of the wheat granule is more resistant to enzyme penetration than the corn. The results of the ICP test show that processed corn starch has significantly (P <0.05) greater ability to absorb iron ions than processed wheat starch. Also, corn starch had a significant difference in iron uptake in the step 1 than steps 2 and 3 (P <0.05), but the data of the second and third steps did not differ significantly (P> 0.05). Hydroxyl groups of D-glucose units in starch granules bond with iron ions and FTIR spectrums give drop at 575 (cm-1) wavelengths. This study showed that enzymatic treatment and ultrasound led to the native corn starches convert to porous starches. The corn starch is more suitable than the wheat because the wheat is more resistant and the cavities were rarely formed. The corn porous starch is a suitable carrier for iron ions.
Narges Hadigol; Maryam Fahim danesh; Sepideh Hoseini
Abstract
Introduction: Pomegranate peel is an important source of bioactive compounds which have high potential of alternative source of activated carbon for bleaching and the removal of heavy metal from liquid media. The present study was undertaken to evaluate the feasibility of pomegranate peel carbon for ...
Read More
Introduction: Pomegranate peel is an important source of bioactive compounds which have high potential of alternative source of activated carbon for bleaching and the removal of heavy metal from liquid media. The present study was undertaken to evaluate the feasibility of pomegranate peel carbon for the removal of heavy metal from oil and aqueous solution and then to investigate its activity in the bleaching of sesame oil.
Materials and methods: Response surface methodology and Box-Behnken design were applied to study and optimize the adsorption condition to remove metal ions on prepared pomegranate peel adsorbent. For this purpose, the effects of three independent variable pH(X1), contact time (X2) and adsorbent dose (X3) on metal ions concentration (dependent variable) were studied using a three-level three-factor Box–Behnken design. In addition, different types of adsorbents (pomegranate peel carbon and activated earth) were tested for adsorption of pigment, peroxides and heavy metals of sesame oil.
Results and discussion: Results showed that optimum condition required for maximum adsorption were found to pH= 5.3, equilibrium time 200 min and adsorbent concentration 2.5 g/L. Under the optimal conditions the removal of heavy metals i.e. Fe, Cr, Pb, as and Hg from aqueous solution by activated carbon developed from pomegranate peel are more than 80%. Results of sesame oil bleaching with pomegranate peel carbon showed good bleaching efficiency and oxidative stability. Furthermore, pomegranate peel carbon comparing with bleaching earth showed better ability to decrease heavy metal content of oil.
